Autopage Telematics and Tracking Module Manual de Instalação

7/9/2008 RS-603 REV A. 1 C3-RS-603 PROFESSIONAL REMOTE CAR STARTER With Two Way data Port

7/9/2008 RS-603 REV A. 10 +12VMaster Door Lock SwitchXX Splice Splice Cut the ExistingLock WireTo Door Lock Motors Cut the Existing Unlock Wire 3 Pi

7/9/2008 RS-603 REV A. 11PROGRAMMING A. PROGRAMMING TRANSMITTER: Note: This remote start system will only retain the last 4 remote transmitters pro

7/9/2008 RS-603 REV A. 12FEATURE “II” PROGRAMMING: 1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in the ‘OFF’ position. 2 Push the

7/9/2008 RS-603 REV A. 13 Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes

7/9/2008 RS-603 REV A. 14 1 (-) Safety Shutdown input (Hood) 1. Close the hood. 2. Check H3/3 White/ Black wire connection. 1 (+) Safety Shut

7/9/2008 RS-603 REV A. 15than park or neutral, the mechanical function will not allow the key to be turned to the start position or be removed from t

7/9/2008 RS-603 REV A. 16 + 12 V Ignition Key In Sensor Switch Closes with Key In Ignition Cylinder Drivers Door Pin Switch 87a 86 30 87 85 Key In

7/9/2008 RS-603 REV A. 17 It is recommended to have a minimal digital service plan on your cell phone

7/9/2008 RS-603 REV A. 18 Your RS-603 is CI3 compatible and will open your world to the true power of two way communication. Complete tracking and fu

7/9/2008 RS-603 REV A. 19 BLANK

7/9/2008 RS-603 REV A. 2 TABLE OF CONTENTS This device complies with part 15 of the FCC rules. Operation is subject to t

7/9/2008 RS-603 REV A. 20 Auto Page, Inc. 960 Knox Unit #B Torrance, CA 90502 www.autopageusa.com

7/9/2008 RS-603 REV A. 21 Toll Free Tech Support Hotline: 800-945-2527 (For certified installation technicians only)

7/9/2008 RS-603 REV A. 3 INTRODUCTION INSTALLER WARNINGS This Remote Starter System is designed to be installed on fuel-injected vehicles with an au

7/9/2008 RS-603 REV A. 4 INSTALLATION DIAGRAM C3-RS-603H1 6 Pin Wht.H2 5 PinH3 10 Pin WhiteH4 ValetH5ANT.H6 DLH7LEDRX-300AValetSwitchViolet : S

7/9/2008 RS-603 REV A. 5WIRING Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass through holes o

7/9/2008 RS-603 REV A. 6 H2: 5 PIN WIRE HARNESS: H2/1. RED/WHITE WIRE –PARKING LIGHT RELAY INPUT -- The RED/WHITE wire is the input to the flashing

7/9/2008 RS-603 REV A. 7To: White/Black Wire / Negative safety To Vehicle Brake Switch Hood Pin SwitchDiode H3/4 BLACK/WHITE WIRE (-)Neutral

7/9/2008 RS-603 REV A. 8This wire is designed to by-pass shock sensor module. This wire will supply an output at all times the remote start is operat

7/9/2008 RS-603 REV A. 95. Connect the previously s resistor from terminal #87 to the second(#2) wire (as shown). To + 12 VIgnition Switch YELLOW wi